AuctorPlayFlash a board
Development software. This puts the current AuctorPlay build on a board, from this page, with nothing to install. The software for sold devices will be protected (signed and encrypted) and is flashed at the factory; until then this is for makers.
Latest release: ...
- Plug the board into the computer with a USB cable that carries data.
- Press Flash this board and choose the board in the list the browser shows (it is called "USB JTAG/serial debug unit" or similar).
- Wait until it says Done. The board restarts by itself.
The board does not show up, or the flashing fails
- Unplug the board, hold the BOOT button (the one next to the USB plug) while you plug it back in, then let go and try again.
- Use another USB cable or port: some cables only carry power.
- Close other programs or tabs that use the board (a serial monitor, for example).
- Tick Erase everything first and flash again.